RAW

C

Dry Coolers

Certificazione-IQNET    Certificazione-SQS

Closed-circuit, indirect exchange liquids chillers operating with water or a glycol/water mixture and employing the ambient air as cooling fluid.

A careful selection of the exchange batteries allows to obtain process fluid temperatures nearing the sucked air temperature.

“RAW” Series Dry Coolers

These closed-circuit, indirect exchange liquids coolers use the ambient air as a refrigerating fluid. They are designed to cool process liquids by means of a dedicated fin-pack exchanger. The exchanger is crossed by the ambient air flowing in an opposite direction as to that of the liquid to be cooled. Thanks to a special exchanger size, the temperature difference between the cooled liquid and the air is reduced to a minimum (the nominal cooling power provides for a 5°C temperature difference). A carefully studied sizing allows to cut this difference down to 3°C. These environment-friendly “RAW” series coolers simply use a water/antifreeze solution as cooled liquid, with ambient air as cooling fluid. For applications where the antifreeze liquid cannot be added to the hydraulic system we have designed the special “RAW / S” model allowing manual or automatic emptying of the exchanger, so as to avoid any breakages due to low temperatures. (N.B.: this application entails special installation requirements). The “RAW” series offers a wide choice of units specially designed for energy saving. The top quality materials employed allow to reach high efficiency values (high ratio of chilling yield to electric consumption in kW). A special model is the “RAW / C” version, which is fitted with centrifugal fans and inverter control. For process liquid temperatures of 25°C and above, the “RAW / C” allows to recover energy by producing clean, warm air that can be employed for plant heating. RAW / E model Fitted with axial fans and fans’ speed controller for up to 570 kWf cooling power.

Control Panel

Electronic microprocessor allowing to select and display the chilling liquid’s inlet and outlet temperatures. It controls the unit’s operation and reports any alarm conditions, allowing the remote diagnostics of anomalies also by means of a serial connection. The standard version is equipped with alpha-numeric display showing the unit’s status.

Liquids coolers

Standard
Components

  • Zinc-coated body suitable for external installation.
  • Air/water exchanger with wide exchange surface.
  • AISI 304 stainless steel centrifugal motor pump.
  • Vertical-air discharge centrifugal fans.
  • IP55 protection degree.
  • Microprocessor control.
  • Fans speed control (“RAW / E” version).
  • Control panel.
  • Washable alluminium filters on the air-suction side.
  • Automatic air exhaust.
  • Remote alarms.
  • Water pressure gauge.
  • Automatic filling.





I hereby consent to the processing of my personal data in compliance with the relative European Regulation. For further information, please consult the Privacy Policy .

Raffreddatori di liquidi

Optional Components

  • Centrifugal fans’ speed analogue regulator (INVERTER)
    for warm air production with externalinstallation
    (for “RAW / C”).
  • Centrifugal fans soft-start.
  • Remote control panel.
  • Second electrical motor pump for safety.
  • “CAM” automatic water / glycol mix.
  • Automatic by-pass.
  • Air ducts for air discharge (with centrifugal fan).
  • Supercooling exchanger.
  • Automating emptying (“RAW / S” version)
frigofluid Cooling Systems
Send